Carburetors & Parts

Good condition. Original OEM Yamaha used part. Rubber is soft and not cracking. Hardware has surface rust. Includes balancing port cap. Yamaha part number: 10L-13596-01-00, 10L-13586-01-00. Fits Yamaha: XV750 VIRAGO 1981-83 XV750M VIRAGO 1983 XV920 VIRAGO 1982 XV920R VIRAGO 1981 1981-83 Yamaha XV750...

Good condition. # J9T01971. 1984-85 Yamaha XV1000 Virago Boost Sensor J9T01971

Good condition. Carb set is complete. No scoring on sliders. All moving parts are free and functioning. Will need a thorough cleaning before use as they are old and have been sitting for a while. Caps and hardware are pitted with surface rust.

Good condition. All moving parts are functioning freely. No visible scoring on slides. Inside looks quite clean but should still be cleaned inside and out before use. Finish is tarnished. Caps have surface rust. Yamaha part number: 12R-14900-00. Fits Yamaha: XS400 MAXIM 1982-83 1982-83 Yamaha XS400 Maxim...

Good condition. No cracks or splits in rubber. O-ring seals are intact. Includes carb clamp bands. NOTE: These are the offset rubbers that fit the XS400 Maxim, not the XS400 Special.

Good condition. No cracks or damage. Includes clamp bands.

Good condition. Rubber is good with no cracks. Includes clamp bands. O-rings should be replaced for best seal.

Good condition. Carb set is complete. Should be cleaned before use as they are old and have been sitting for a while. Caps are pitted with surface rust.

Good condition. No cracks in rubber. Includes 8 clamp bands. Honda part number: 16211-MB0-000. Fits Honda: VF700C MAGNA 1984-86 VF700C SUPERMAGNA 1987 VF700F INTERCEPTOR 1984-85 VF700S SABRE 1984-85 VF750C MAGNA 1982-86 VF750C MAGNA 1988 VF750F INTERCEPTOR 1983-85 VF750S SABRE 1982-85 1982-88 Honda VF700...

Fair condition. Carburetor set needs a rebuild and clean. Choke is sticking. One drain nozzle is broken off. 1973-74 Yamaha TX500 Carburetors 2

Good condition. Needle is straight. No scoring on slide. Includes spring, cap, nylon washer, slide height adjuster.

Fair condition. Complete other than rubber cable boot. Has been sitting for a long time. Will need cleaning and possibly re-build.

Good condition. Removed from a crashed 2012 America with approximately 7000km. Rubber is soft and pliable with no cracks or damage. Includes 4 clamp bands in good condition.. Sold as a pair. Triumph part number: T3010096, T2401010. Fits Triumph: America EFI 2008-2020 Bonneville 2017-2020 Bonneville EFI...

Good condition. Original Yamaha Mikuni SU type carburetor No visible damage Carb is complete and undamaged Will need a serious cleaning/overhaul, as expected for a used carb - see pics 1980-82 Yamaha SR250 Exciter Carburetor Mikuni SU type

Good condition. Carburetor assembly is complete. Should be cleaned before use. All moving parts are functioning freely. All rubber parts appear to be in good condition. Honda part number: 16100-148-708. Fits Honda: PA50II HOBBIT 1978-83 1978-83 Honda PA50II Hobbit Moped Carburetor 16100-148-708

New - removed from a new set of Mikuni VM Carbs. Dimensions : 35.5mm x 40mm Cutaway : 3.0 Guide Pin Groove Width : 2.60 Idle Groove Position on Left Guide Pin Position on Right Fits VM30, VM32, & VM34 Brass Please check carbs before ordering. Mikuni VM carbs are left side/right side interchangeable....

Good condition. Mikuni BV18. Likely from a Kawasaki mini bike. Includes engine manifold. Includes filter housing. May need cleaning and seals - has been idle for a long time.

Good condition. Needs cleaning. All connectors, adjusters, etc. are intact. All moving parts are operating freely. Caps are pitted and tarnished.

Good condition. Complete. All moving parts are functioning freely. No visible scoring on the slides. Will need a good cleaning.

Good condition. No visible damage. All linkages move freely, no corrosion. 2007-08 Hyosung GV650 Aquila HN91 Carb Bank

Good condition. No visible damage. Missing one hose. Mikuni part number: RV11-106. Hyosung part number: 18500HP9500. Fits Hyosung: GV650 Aquila 2008 2008 Hyosung GV650 Aquila Air Valve Assembly RV11-106 18500HP9500

Fair condition. Includes 2 engine intake rubbers. Will need cleaning and rebuild. Rubber components are deteriorated. Fits 1974-1977 Suzuki GT380.

Good condition. No significant damage. Complete set of four Mikuni carbs. Includes all linkages and cable mounting bracket. Butterflies, linkages, and slides all move freely. These are used carbs so they will need a good cleaning. 1983 Suzuki GSX750ES Complete Carb Bank

Good condition. Complete. All moving parts are functioning freely. Will need to be cleaned for optimal performance.

Good condition. All moving parts are functional. Will need a thorough cleaning inside. Finish is tarnished throughout. No scoring on the sliders. Please note the configuration of the choke actuator as there seems to be 2 versions. 1981-83 Suzuki GS650G Carburetor Bank

Good condition. OEM Suzuki / Mikuni carb intake boot rubber Boot is in good condition, no significant damage Includes band clamp - see pic 1983 Suzuki GN250D Intake Boot Rubber

Good condition. OEM Suzuki / Mikuni carb Carb is in generally good condition, no significant damage Throttle butterfly and choke slide move freely Carb will need a good cleaning, metering slide is glued stuck in old gas 1983 Suzuki GN250D Carburetor

Good condition. After-market trim that covers the area between the intake tubes. Chrome is good with some very minor blemishes. No dents. Eagle emblems are intact in very good condition. Sold as a pair. 1980-83 Honda GL1100 GL1100A GL1100I Goldwing Carburetor Trim - Pair

Fair condition. All moving parts are free and correct. Finish is heavily tarnished. Chrome is peeling from the intake pipes. Intake pipe boots are good. Will need a thorough cleaning before use. 1980-81 Honda GL1100 Goldwing Carburetor Set 2

Good condition. After-market trim that covers the area between the intake tubes. Chrome is decent with some pitting on the upper section. No dents. Eagle emblem is intact in very good condition. 1980-83 Honda GL1100 GL1100A GL1100I Goldwing Carburetor Trim